General Questions
Please see the general FAQs of PenMount resistive touch controllers below. If you can't find the answers you want below, please mail to us.
The PenMount 6000 /6010/ 9000 series support 4 / 5 / 8-wire resistive touchscreens. 1. PenMount 6000/ 6010 controllers support 4 / 5 / 8-wire resistive touchscreens and RS-232 or USB interfaces. 2. PenMount...
Read moreThe PenMount 6000/ 6010 series offers the latest models of resistive touch controllers. PenMount 6000/ 6010 controllers operate more smoothly and support USB and RS-232 interfaces.The PenMount 9000 series...
Read morePlease contact our sales window. We will provide you with a "Hardware Application Guide" which includes relevant specifications, reference circuit diagrams, and a byte order mark (BOM) table to expedite...
Read morePenMount resistive touch controllers coupled with an appropriate mechanical design can meet IEC61000-4-2 ESD testing standards: Air Discharge 15KV, and Contact Discharge 8KV.
Read more1. RS-232 Cable: About 12 meters. 2. USB Cable: About 3 meters.
Read moreAfter the driver is installed, please perform calibration first to make sure the cursor works accurately.
Read moreYes. We can provide an instructions manual to help you set up multiple monitors.
Read moreNo. WinCE does not support two or more devices. Linux can only support one PenMount device. If you have a special requirement for two PenMount devices, please contact our sales staff.
Read moreThe architecture of ARM or MIPS is RISC (Reduced Instruction Set Computing). Please contact our sales staff. We will provide you with PenMount's Linux kernel driver source code for you to drive your PenMount...
Read more